Sparx Single Phase Powerbox Instructions
SPARX Single Phase POWER Box
If you have 12 volt 2 wire stator simply connect the White / Green
wire and the Green / Yellow wire to either of the yellow AC wires
of your SPARX box. The Red + and Black - then simply connect to
your motorcycle wiring. ( see diagram below)
|
|
Important
**Single & Three phase boxes***
Due to the sensitive nature of both the single and three phase
boxes it is VERY important to fit spark plug caps of the 5000ohm
resisted type.
Failure to do so will cause overloading.
|
|
|
If you have an old 6 volt 3 wire
stator you can convert it to 12 volt by joining the green/black and
green/yellow wires together then connecting those two to one of the
yellow AC wires and then connecting the green/white wire from the
stator to the other yellow AC wire of your SPARX box, Then the Red +
and the Black - connect into your motorcycle wiring. Please do not
forget to change your Battery, bulbs, horn etc. to 12 volts also!!!!
( see diagram below ). |
|
|
SPARX Electrics are designed to
give reliability and a higher output than standard items especially
at the lower rev ranges. Why not upgrade your motorcycle electrics
today.
SPARX Single phase 'POWER BOX' regulator rectifier
Enhance your electrics with the FULL Three Phase 210 Watt
Alternator Kit
Please Note: When using SPARX regulator rectifiers you must use
resisted spark plugs as circuitry is sensitive. Using unresisted
plugs can cause over charging.
|
|