Vincent "Stop" Taillight LED Conversion Kits

Part Number 394-01/LED & 394-01/LED/A

This LED "STOP" Lamp Conversion kit features a uniquely designed LED Board assembly which will fit the popular Miller taillight assemblies found on most HRD/Vincents and some Velocettes for a reliable conversion. Some assembly and taillight modifications are required. 6 or 12 volt kits are available. Fits Most Miller "STOP" Lamp assemblies for HRD, Vincent, and some Velocettes.

Choose the right kit for your build!

394-01/LED - VINCENT "STOP" LAMP LED CONVERSION, 12V
394-01/LED/A - VINCENT "STOP" LAMP LED CONVERSION, 6V

Installation takes 60 minutes or less.

LED Board Features

Designed for optimum installation in reproduction Miller "STOP" lamp assemblies
"Selectable Ground" for use with either Positive Earth or Negative Ground.
16 Ultra-bright Red LEDs.
3 White LEDs for the lighting of the license plate.
Surface mounted components.
Plug-in cable assembly for ease of connection.
Aluminum and stainless steel hardware.
Available in either 6 or 12 volts.
Draws only .13 Amps (Low) & .65 Amps (High).

Each Kit Contains The Following Items

Fully illustrated step-by-step installation instructions.
Ultra-bright LED Board designed to operate in low and high intensities using the same LEDs.
Plug-in cable assembly.

LED Board Dimensions

2.58" Diameter (65.5mm)
Approximately 1.08" Thick (27.4mm)

Part Number 394-01 shown for illustrative purposes and is SOLD SEPARATELY.