Adjuster Assembly, MK3 Gearbox Top, Stainless
Part Number 06-4697/A
Aftermarket accessory to allow some movement of Commando MK3 gearbox when a belt drive is fitted.
DESIGNED FOR SPECIAL APPLICATIONS TYPICALLY WHEN THE TOP BOLT FITS IN A HOLE RATHER THAN A SLOT.
THE ORIGINAL TENSIONING LOLLIPOP AND ANCHOR IS NOT REQUIRED AND THIS BOLT GIVES APPROXIMATELY 4.5MM
OF ADJUSTMENT WHEN ROTATED VIA THE SMALL LEVER ATTACHED TO THE HEAD.
TYPICALLY IT IS USED ON THE
MK3 COMMANDO WHEN FITTING A BELT DRIVE THE SMALL AMOUNT OF ADJUSTMENT BEING ENOUGH TO COMPENSATE
FOR THE VARIATIONS FOUND BETWEEN CENTRES. IT COULD ALSO BE USED ON SPECIALS AND COMPETITION
EQUIPMENT WHEN A FIXED CENTRE SET UP IS PREFERRED.
ADDITIONAL ADVANTAGE IS IT EFFECTIVELY ADJUSTS
THE GEARBOX FROM BOTH SIDES AND THE BOLT BEING DESIGNED WITH THE RIGHT HAND GROOVE .015" DEEPER
HELPS WITH SHAFT ALIGNMENT AS THE MAINSHAFT'S INVARIABLY LEAN FORWARD TOWARDS THE CRANKSHAFT.
